Less operator input is required while providing better accuracy, reduced operator fatigue and faster travel speeds.
Mounted on the carrier’s steering levers, fingertip controls provide quick and easy access to make elevation changes or switch the automatic function on or off, delivering precise and accurate results with maximum operator comfort.
While in automatic mode, if the operator pushes a switch to move the blade up or down, automatic mode is momentarily interrupted. When the operator releases the switch, the system immediately returns to automatic mode.
Deliver a 360-degree operating range. Provide visible indication of where the blade is relative to the ground and an automatic mode indicator.
Move the grade up/down, in 0.1-inch (or 2.5 mm) increments up to 2 inches in either direction, making it easier for the operator to make adjustments on-the-fly without leaving the cab to raise or lower the transmitter.
For ease of use around the jobsite, the laser control system is quickly attached and removed as necessary.
The following components are required to operate this attachment and must be purchased separately:
WARNING: This product can expose you to chemicals including engine exhaust (including diesel engine exhaust when equipped), lead and lead compounds, mineral oils, soots, phthalates, and carbon monoxide which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Certain specification(s) are based on engineering calculations and are not actual measurements. Specification(s) are provided for comparison purposes only and are subject to change without notice. Specification(s) for your individual equipment will vary based on normal variations in design, manufacturing, operating conditions, and other factors.