Home
Parts & Service
Service & Maintenance
Videos
Replace the R-Series Style Filters on Tier 4 Bobcat Engines

Replace R-Series Fuel Filters on Tier 4 Bobcat Engines

This video provides a step-by-step guide to replacing the fuel filter, pre-filter, and breather cap on the Tier 4 Bobcat® engine in Bobcat® R-Series compact track loaders and skid-steer loaders. This guide also applies to select machines of Bobcat M-Series loaders, Bobcat R2-Series excavators, Bobcat compact wheel loaders, Bobcat Toolcat™ utility work machines and Bobcat telehandlers manufactured since 2020 and use part number 7336334 fuel filter. See the video for details.

If your Bobcat machine does not use this filter nor a pre-filter, the video of “How to Change the Fuel Filter on Tier 4 Bobcat Engines” may be more beneficial.

VIDEO LENGTH: 12 minutes and 40 seconds (12:40)

ITEMS NEEDED

Be sure to have a few items ready:

Safety glasses
Work gloves
A genuine Bobcat fuel filter (part number 7336334), available at your dealer, or online.
A genuine Bobcat pre-filter (part number 7348032), available at your dealer, or online.
A genuine Bobcat fuel tank vent or breather cap available at your dealer, or online.
Shop towels or rags
9mm (3/8 in) x 300mm (12 in)-600mm (24 in) extra hose
A filter wrench and other tools

If you need Genuine Bobcat Parts, supplies, or a new operation and maintenance manual, visit the Official Bobcat Shop or contact, or visit your Bobcat dealer.

GET STARTED

Check the operation and maintenance manual before performing any maintenance work, and make sure the engine is cool before starting service.

BOBCAT GENUINE PARTS

Genuine Bobcat parts and fluids are made to protect your machine’s performance. With specs that precisely match your machine’s requirements, you can rest assured that you’ll be ready to work whenever you need your machine. You can order from a wide selection of products online at the Bobcat Shop or visit your local Bobcat dealer.

FIND A DEALER

Quickly find a Bobcat Dealer where you can stock up on a wide selection of Bobcat parts and fluids for your machine. Or schedule a service appointment.

CHECK AND DRAIN WATER

Check the water separator bowl. Only drain when water is visible or when notified by the ‘water in fuel’ code and at every fuel filter replacement. Install an extra hose then loosen the drain.

REMOVE THE OLD FILTER

Service only when required otherwise replace every 1,000 hours or annually. Disconnect the electrical connector and remove the separator bowl. Remove the filter.

INSTALL A NEW FILTER

Do not pre-fill a new filter with fuel. Lubricate the new O-rings. Install the separator bowl before installing onto the filter housing. Connect the electrical. Perform any final cleanup. The fuel system will need to be primed with fuel and air removed from the system.

REMOVE THE OLD FILTER

Clean the pre-filter and area. Move the hose clamps off. Remove each fuel hose and loosen the filter clamp. Note the orientation of the arrow on the pre-filter before removing and discarding it.

INSTALL A NEW PRE-FILTER

Install the new pre-filter with the arrow facing the correct direction. Install hoses and move the clamps back to the correct position. Remove the hose pliers.

PRIME AND REMOVE AIR

Any time a fuel filter is replaced, the pre-filter will need to be primed and air removed from the system.

REPLACING A BREATHER CAP

Your machine may also have a fuel tank vent or breather cap that vents excess pressure. Replace with a new genuine Bobcat part.

VIDEO CHAPTERS:

00:00 – Intro

00:27 – Items Needed & Get Started

00:56 – Check and Drain Water

02:38 – Remove the Old Filter

04:24 – Install a New Filter

06:50 – Remove the Old Pre-Filter

08:56 – Install a New Pre-Filter