Need to spread sand and salt for winter maintenance? The spreader attachment gets it done right and provides the versatility for all types of spreading jobs. Every model resists corrosion and stands up to tough sand and salt combinations.
The HS8 features an 8-cubic-foot hopper with the spread pattern controlled by a hydraulic motor and three flow gates that spread material from 18 feet to 28 feet.
The hopper grate filters unwanted debris from the spread material.
The operator can use the hopper as a bucket, filling the spreader from a pile. Quickly and efficiently reload the spreading material into the hopper for big parking lot or road coverage jobs.
The sidewalk kit keeps material from being cast out of the bounds of the sidewalk; compresses spread pattern between 29 and 38 inches.
The stainless-steel hopper and frame resist corrosion and provide excellent durability for serious work.
Baffles within the chute direct material to key areas on the spinner result in a remarkably even and consistent spread pattern with less material directed back at the vehicle.
A mesh screen at the top of the hopper filters large chunks of sand and salt to produce a consistent, even flow.
A convenient dash-mounted spreader control allows operators to easily adjust the auger and spinner speed to change the spread pattern of up to 30 feet – all from inside the cab.
Dual variable-speed control of the spinner and HELIXX system allow for precise material delivery at low or high output. Also features auto reverse and accessory integration.
Remove a single pin to flip up the chute. Remove two pins to take it off entirely and get easy hitch access and more flexible storage. The molded spinner plug must be removed when flipped for dumping.
An optional vibrator kit attaches to the structural cross member, vibrating the unit’s tub and sill to ensure material flows evenly through the spreader attachment.
The hydraulically powered HS8 can quickly connect to approved tool carriers with the Bob-Tach® attachment mounting system. Its self-loading hopper has an open top and can be used as a bucket to efficiently fill the spreader from a pile rather than pour material into the top. With a hopper volume of 8 cubic feet and a spread pattern that is controlled by three material flow gates, operators can spread material from 18 to 28 feet.
Bobcat also offers two cargo box-mounted spreaders designed for Bobcat® utility vehicles and Toolcat™ utility work machines, the SP9 and SP13, respectively. These tough, stainless-steel units allow for consistent, controlled material spread pattern of up to 30 feet, and they feature dash-mounted controls that are convenient and easy to use. A large 13.5 cubic foot hopper allows operators to carry more material for larger spreading jobs.
The SP9 is compatible with the Bobcat utility vehicles while the SP13 is compatible with the Toolcat utility work machines. Optimized for efficient and cost-effective use of salt, the SP9 & SP13 is compatible with sand and salt mix, bagged rock salt, bulk salt, and dry free-flowing sand.
Conveniently connect accessories directly into the hub in the back of the hopper. Accessories automatically integrate with the hopper control with no additional wiring.
A few accessories Include:
WARNING: This product can expose you to chemicals including engine exhaust (including diesel engine exhaust when equipped), lead and lead compounds, mineral oils, soots, phthalates, and carbon monoxide which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Certain specification(s) are based on engineering calculations and are not actual measurements. Specification(s) are provided for comparison purposes only and are subject to change without notice. Specification(s) for your individual equipment will vary based on normal variations in design, manufacturing, operating conditions, and other factors.