Auger
Attachment

Auger
Attachment

  • Dig holes with speed and plumb-line accuracy using a Bobcat® auger attachment
  • Choose from a direct drive auger for an optimum balance between torque and RPM, or a gear-driven planetary auger for applications that require the most torque 
  • Multiple bit types and teeth to match your digging conditions 
  • Gain extra digging depth over competitive units

Auger Features

Product Overview

Required Components

The following components are required to operate this attachment and must be purchased separately: 

  • A wide variety of auger bits and teeth are available to match your digging conditions 

Compatible Models

Auger Specifications

Units
Auger Drive Unit - 10
Auger Drive Unit - 15C
Auger Drive Unit - 30C
Auger Drive Unit - 30H
Auger Drive Unit - 15H
Auger - 35PH
Auger - 50PH
Operating Weight
151 lb
205 lb
223 lb
217 lb
201 lb
285 lb
285 lb
Length
30.3 in
37 in
37 in
33.4 in
33.4 in
39.7 in
39.7 in
Width
8.4 in
10.6 in
10.6 in
10.6 in
10.6 in
11.6 in
11.6 in
Height
11.3 in
12.7 in
12.7 in
12.7 in
12.7 in
11.4 in
11.4 in
Dig Depth (without extensions)
58 in
62 in
62 in
62 in
62 in
72 in
72 in
Operating Weight (Less Bit)
283 lb
358 lb
376 lb
370 lb
354 lb
454 lb
454 lb
Speed
High 
Medium 
Low 
Low 
Medium 
Low 
Low 
Torque
Low 
Medium 
High 
High 
Medium 
High 
High 

Additional Details

Using heavy-duty hydraulics, the auger attachment bites into any soil condition with ease and efficiency. Even in hard and rocky soil, the high torque keeps the auger steady and powerful to maintain performance. 

Choose between a direct drive auger for an optimum balance between torque and RPM, or a gear-driven planetary auger for applications that require the most torque. Multiple bit types and teeth enable you to find the right auger to match your digging conditions. 

The direct drive 15 offers a higher range of speed for drilling holes quicker through softer to moderate soil conditions such as sand, dry material, and light dirt so the hole being dug is cleaned out better. The direct drive 30 and the planetary drive augers offer higher amount of torque for digging into heavier ground surfaces such as rocky, coral or clay. With lower speeds to dig, Planetary augers provide the torque needed to install screw anchors and dig with bits that are over 24 inches in diameter. 

 

WARNING: This product can expose you to chemicals including engine exhaust (including diesel engine exhaust when equipped), lead and lead compounds, mineral oils, soots, phthalates, and carbon monoxide which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Certain specification(s) are based on engineering calculations and are not actual measurements. Specification(s) are provided for comparison purposes only and are subject to change without notice. Specification(s) for your individual equipment will vary based on normal variations in design, manufacturing, operating conditions, and other factors.